X

LSI/CSI Unveil New Industrial Power Line Driver

By Matt Williams -

LSI/CSI has announced the availability of a new, short-circuit-proof Quad Differential Industrial Power Line Driver. The new IC, designated LS7272B, can operate up to 30V and have a selectable thermal shutdown feature.

The Data inputs are TTL/CMOS compatible and can also be driven up to the supply voltage VDD. The ENA input can be used to place all the outputs in a high impedance state. The OPD input is used to configure the outputs as push-pull drivers or open-drain drivers, where the outputs can be returned through external loads to a maximum voltage of VDD. LS7272B-20 does not have OPD pin and its outputs are always in a push-pull configuration.

An internal 5V regulated supply is used to power the logic and level converter blocks. The thermal shutdown block located in the centre of the IC can be disabled by setting the ENA input, Pin 12, to a voltage between 7.5V and 12V.

Upon power-up, a Power-On-Reset (POR) circuit block forces all output drivers to the high-impedance state until the power supply voltage reaches a nominal 3.9V. Included in the POR circuit block is a hysteresis of 200mV such that if the power supply drops below 3.7V all output drivers are forced to the high-impedance state until the voltage rises above 3.9V. There is a built-in 5μs delay for disabling the output drivers should the power supply drop below 3.7V. The output drivers are immediately enabled when the voltage rises above 3.9V.

 

Features:

  • More feature-rich and cost-effective than the OL7272
  • Pin for pin replaceable with the OL7272
  • Push-Pull or Open-Drain output drivers
  • Voltage Range: 4.5V – 30V (VDD – VSS)
  • 1A peak dynamic Sink/Source output drive
  • Operating frequency up to 2 MHz
  • Thermal shutdown protection for output driver overload
  • Enable input with Thermal Shutdown disconnect feature
  • Outputs RS422A compatible
  • Inputs CMOS/TTL compatible with hysteresis
  • Output drivers fully connected or high-impedance stat

For more information, email sales.europe@macnica.co or visit Macnica

Also, stay up to date with the most recent machine vision and image processing news right here on MVPro Media.

 

Most Read

Fives & mon-marché.fr To Revolutionise Shopping

byMatt Williams

September 28, 2022

Fives, one of the world's most preferred partners for transforming supply chain facilities, has been...

Prophesee: EU’s Most-Funded In Fabless Chips

byMatt Williams

September 26, 2022

Prophesee, the inventor of the world’s most advanced neuromorphic vision systems, has announced the completion...

Optomotive To Unveil Two New Products At VISION

byMatt Williams

September 28, 2022

Optomotive, manufacturer of cutting-edge, high-performance cameras and 3D smart sensors, has announced two brand-new products,...

SMC: 4 Ways To Increase Vacuum Efficiency

byMatt Williams

September 27, 2022

With energy prices surging across Europe, efficiency has become a high priority for all manufacturing...

Teledyne Introduces AxCIS Contact Image Sensors

byMatt Williams

September 28, 2022

Teledyne DALSA has introduced AxCIS ™, a new family of high-speed and high-resolution fully integrated...

Xenics introduces DIONE 1024 Camera Core

byMatt Williams

September 27, 2022

Dione 1024 has been announced today as the new member of the long-wave infrared (LWIR)...

Women In AI: Startup Event On 29th September

byMatt Williams

September 27, 2022

Women in AI will present their very first free startup community event at Wayve Technologies...